SCPRO 4A BT is an installation amplifier inside SCPRO Series, with attractive features which allow to make a big number of installations and diversified control possibilities.
It has a sensitivity adjustment from -infin to 0dB and two operating modes: Bridge (normal mode) and Parallel (for additional configurations). The shutdown function allows to enable the standby mode remotely.
Together with the previous features, SCPRO 4A BT integrates Bluetooth compatibility, being able to play audio signal from devices like smartphones. This signal will mix with the analogic audio input.
| SCPRO 4A BT |
Output Power (Bridge) | 1 x 40W 8 Ohm (24Vdc) |
Output Power (Parallel) | 2 x 20W 4 Ohm (24Vdc) |
Sensitivity Vrms | 225mVrms(bal) / 450mV(unbal); sens 0dB |
Output monitor Level Vrms | 890 mVrms (nominal input line) |
Recommended Power Supply | 24 Vdc - 1.7A |
THD+N | <0.08% |
Function modes | Parallel / Bridge |
Gain | 20dB |
Minimum Load | Parallel 4 Ohm / Bridge 8 Ohm |
Dimensions (WxHxD) | 99x30x89 mm |
Weight | 240 g |
|
SCPRO 4A BT |
Terminal block |
14 pin Euroblock connector |
Sensitivity |
Knob from -infin to 0dB |
Function mode selector |
Parallel / Bridge |
Input |
Bal. 3 pin (IN+, IN-,
GND) / Unbal. 2 pin (IN+, GND) |
Shutdown function |
1 pin (SD_TPA) + 1 pin GND |
Monitor Output |
Bal. 3 pin (Out+,
Out-, GND) / Unbal. (Out+, GND) |
Speaker 1 |
2 pin (+, -) |
Speaker 2 |
2 pin (+, - ) |
Power |
2 pin (24 VDC, GND) |
#1 | Manual | SCPRO_SERIES_MANUAL | ![]() | Download |